Initial Setup; Turning The Tv On For The First Time - JVC LT-32E35B Instruction Manual

Chapter
4

Initial Setup

4

Turning the TV On for the First Time

GB
If you are going to watch TV using a set-top box, simply connect your TV and set-top box via a HDMI cable and select HDMI
in the Input Source menu.
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear right side
of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. Switch on the POWER ON/OFF switch which is
located at the front right side under the frame. At this
stage, the TV switches to standby mode. The red LED
indicator will illuminate on the front panel of the TV.
4. In standby mode, press the
right side under the frame or on the remote control to
turn on your TV. The red LED indicator will turn off.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button at the front right side under the frame or on the remote control is only used for switching the TV into
standby, it does not disconnect the TV from the mains power. To completely disconnect the mains power, please remove
the mains plug from the mains socket or switch off the POWER ON/OFF switch.
5. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please go to the section "Selecting the Input Source" on the next
page.)
6. Press the
displayed on the menu. The default on-screen menu language is set as
English. Press the OK button to confirm.
18
button at the front
buttons to select your desired language to be
COMMON INTERFACE (CI)
USB HDMI2(ARC)
HDMI1 HEADPHONE YPbPr
5V 500mA
Please ensure aerial is plugged in!
Please select an OSD Language
English
Svenska
Dansk
OR
RF coaxial cable
(not included)
RF
To the mains
socket
First Time Installation
Then press [OK] button.
Suomi
Česky
Slovak
Norsk
OK