Table of Contents
Advertisement
Chapter
4
Initial Setup
4
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear right side
of your TV.
Do not connect the TV to the mains
supply until you have completed all the
connections.
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. Switch on the POWER ON/OFF switch which is
located at the front right side under the frame. At this
stage, the TV switches to standby mode. The red LED
indicator will illuminate on the front panel of the TV.
4. In standby mode, press the
panel of the TV or on the remote control to turn the
TV on. The red LED indicator will turn blue.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the right side panel of the TV or on the remote control is only used for switching the TV into standby, it
does not disconnect the TV from the mains power. To completely disconnect the mains power, please remove the mains
plug from the mains socket or switch off the POWER ON/OFF switch.
5. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please go to the section "Selecting the Input Source" on the next
page.)
6. Press the
buttons to select your desired language to be
displayed on the menu. The default on-screen menu language is set as
English. Press the OK button to confirm.
7. Press the
buttons to select your desired mode and then press the
OK button. Press the
button to select Yes to confirm or the
to select No to cancel and return to the Mode Select menu.
Home Mode
Intended for use in home environment.
Shop Mode
Intended for use in retail environment.
• For the best picture quality in your home environment, we recommend setting the TV to Home Mode.
• In Shop Mode, the default Picture Mode under the PICTURE menu is set as Dynamic (please refer to page 30 for
details) and the Backlight is set as 10 (please refer to page 31 for details).
USB
5V
500mA
button on the right side
COMMON INTERFACE (CI)
HDMI2
HDMI1(ARC)
HEADPHONE
PC AUDIO
To the mains
socket
Please ensure aerial is plugged in!
Then press OK button.
Please select an OSD Language
English
Svenska
Dansk
button
Home Mode
Shop Mode
OR
RF coaxial cable
(not included)
PC IN
RF
First Time Installation
Česky
Suomi
Slovak
Norsk
OK
Mode Select
OK
GB
17
Advertisement
Table of Contents
