Table of Contents
Advertisement
Available languages
Available languages
Chapter
3
Initial Setup
3
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the ANT socket on the back of your TV.
Do not connect the TV to the mains supply until you have
completed all the connections.
2. Plug the TV into a mains socket and switch on at the
mains.
3. In standby mode, press the
control to turn the TV on. The LED indicator will flash
for a few seconds then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
The first time you turn the TV on, it will go straight into the First Time
Installation menu. Most of the settings are pre-set so you can just press OK.
Please ensure the aerial is plugged in.
4. Press the
buttons to highlight your LANGUAGE then press OK.
5. Press the
buttons to highlight your COUNTRY then press OK.
6. Select Home Mode by pressing the OK button.
7. Press the
buttons to highlight your desired picture mode. Its set to Natural
as this is the most energy efficient mode. Then press OK.
JVC 55' LED Smart 4K HDR TV LT-55K890(B) Manual GB GR.indd 19
button on the remote
RF coaxial cable
with 'F Type' connector
(not included)
LAN
LNB
13V dc/18V dc
VGA
SPDIF
Optic.OUT
AV IN
RF coaxial cable
(not included)
19
18/10/2019 15:45
Advertisement
Table of Contents
