Table of Contents
Advertisement
Chapter
4
Initial Setup
4
Turning the TV On for the First Time
• This instruction manual explains the basic instructions for operating this unit. Unless otherwise stated, all operations
described are based on remote control use.
• When an item in main menu is displayed gray, it means that the item is not available or cannot be adjusted.
• If you are going to watch TV using a set-top box, simply connect your TV and set-top box via a HDMI cable and select
HDMI in the Input Source menu.
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear right side
of your TV.
Do not connect the TV to the mains supply
until you have completed all the connections.
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. At this stage, the TV switches to standby mode. The
red LED indicator will illuminate on the front panel of
the TV.
4. In standby mode, press the center of joystick function
button under the TV frame or the
the remote control to turn on your TV. The red LED
indicator will turn off.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The center of joystick function button under the TV frame or the
switching the TV into standby, it does not disconnect the TV from the mains power. To completely disconnect the mains
power, please remove the mains plug from the mains socket.
5. The first time you turn the TV on, it will go straight into the First Time
Installation menu. Please ensure the aerial is plugged in and then press
the OK button. (If you have already installed the TV using the Quick Start
Guide, please go to the section "Selecting the Input Source" on the next
page.)
If you are going to watch TV using a set-top box, press the EXIT
button on the remote control then skip this section. Then press the
INPUT button on the remote control to select HDMI mode.
6. Press the
buttons to select your desired language to be
displayed on the menu. The default on-screen menu language is set as
English. Press the OK button to confirm.
RF coaxial cable
To the mains
button on
OR
(not included)
COMMON INTERFACE (CI)
LAN
RF
PC AUDIO
YPbPr
socket
button on the remote control is only used for
First Time Installation
Please ensure aerial is plugged in!
Then press [OK] button.
Please select an OSD Language
Czech
Slovak
Finnish
HEADPHONE
AV IN
Danish
English
Swedish
Norwegian
OK
23
Advertisement
Table of Contents
