Table of Contents
Advertisement
Initial Setup
4
Target Region Setting
GB
During tuning your TV may have received signals from more than one
transmitter. If this has occurred the Target Region Setting screen will be
displayed. This will enable you to select the correct regional transmission for
the local news service that you require.
buttons to adjust each option's setting and then press the OK
Press the
button to confirm.
Country Code
Primary Region
Secondary Region
Tertiary Region
Eco Friendly / Auto Standby Function
The latest eco-friendly power saving technology will automatically switch the TV into standby mode if the TV is left on and idle
for 4 hours or it does not receive an input signal for serveral minutes. A reminder screen will pop up and count down before the
switches to standby mode. Once the TV is switched to standby mode, the red LED indicator will illuminate on the front panel of
the TV.
Press the
button at the front right side under the frame or on the remote control to turn on your TV. The red LED indicator will
turn off and a pop up message will be prompt on the screen AFTER wake up from standby.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The
button at the front right side under the frame or on the remote control is only used for switching the TV into
standby, it does not disconnect the TV from the mains power. To completely disconnect the mains power, please remove
the mains plug from the mains socket or switch off the POWER ON/OFF switch.
Selecting the Input Source
1. Press the
button on the remote control to display the Input source list.
2. Press the
ATV / AV / YPbPr / HDMI1 / HDMI2 / USB.
3. Press the OK button to confirm your selection. If you do not press the OK
button to confirm, the TV will automatically confirm the selected input
source within 4 seconds.
Alternative
• Press DTV button or CH+ / – button to switch to DTV mode
directly.
• Press the HDMI button repeatedly to switch between HDMI1 /
HDMI2.
20
This will be shown as GBR for the UK.
This will show the regional country (e.g. England,
Wales, Scotland, NI).
This will allow you to set the region for your local
news service on BBC and ITV (e.g. London, Beds
and Cambs etc).
You may receive signals from more than one
transmitter within the Secondary Region, (e.g Beds
and Cambs may have Luton or Sandy Heath).
button at the front right side under the frame or the INPUT
buttons to select the input source that you want: DTV /
Target Region Setting
Country Code
Primary Region
England
Secondary Region
London
Tertiary Region
OK
Input Source
DTV
ATV
AV
YPbPr
HDMI1
HDMI2
USB
OK
GBR
Hide quick links:
Advertisement
Table of Contents
