Initial Setup; Turning The Tv On For The First Time - JVC LT-65C880 Instruction Manual

Chapter
3

Initial Setup

3

Turning the TV On for the First Time

Do not connect
the TV to the
mains supply
until you have
completed all the
connections.
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on
the back of your TV.
2. Plug the TV into a mains socket and switch on at the mains.
3. In standby mode, press the
then the TV will switch on.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
The first time you turn the TV on, it will go straight into the First Time
Installation menu. Most of the settings are pre-set so you can just press OK.
Please ensure the aerial is plugged in.
4. Press the
5. Press the
6. Select Home Mode by pressing the OK button.
7. Press the
as this is the most energy efficient mode. Then press OK.
14
JVC 65' LED Smart 4K HDR TV LT-65C880(C) Manual.indd 14
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
buttons to highlight your LANGUAGE then press OK.
buttons to highlight your COUNTRY then press OK.
buttons to highlight your desired picture mode. Its set to Natural
VGA LAN Optic.OUT ANT.
RF coaxial cable
(not included)
HDMI 1
07/11/2018 11:00