JB Systems COB-4BAR Operation Manual page 8

ENGLISH
SLAVE MODE + FOOT CONTROLLER
Used to set the unit in slave mode when you want to have synchronized effects with the master unit.
(when the first unit is running it's automatic programs or is set in a fixed color)
Used when you want to control the bar with the optional foot controller
 Press the MODE button until SLAVE is shown on the display.
 Press the ENTER button to confirm.
IMPORTANT: If you want to use the automatic modes and make the settings directly on the bar, you
need to deactivate the IR remote control receiver in the bar. (IR ACTIVE = OFF)
SOUND MODE
Used to set the parameters for the automatic Sound Mode.
 Press the MODE button until SOUND MODE is shown on the display.
 Press the ENTER button to enter the configuration mode
 The value of the sensitivity (SENS) will start blinking on the display
 Use DOWN and UP buttons to change the sensitivity of the build-in microphone (00 = minimal sensitivity,
31 = maximal sensitivity).
 Press the ENTER button to confirm.
 The value of the frequency (FQN) will start blinking on the display
 Use DOWN and UP buttons to change the number of times each automatic program should be repeated
before to go automatically to the next automatic program.
 Press the ENTER button to confirm.
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
STATIC COLOR MODE:
Used to set a static color for the projectors.
 Press the MODE button until 01.STATIC or xx.EFFECT (number 02 to 14 followed by EFFECT) is shown
on the display.
 Press the ENTER button to enter the configuration mode
 The actual mode (static or effect mode) is blinking on the display
 If necessary, use the DOWN and UP buttons to select 01.STATIC
 Press the ENTER button to enter the configuration mode for the static colors
 Use DOWN and UP buttons to select COLOR_CW (cold white), COLOR_WW (warm white) or COLOR
SET (to compose your own color).
 If you have chosen COLOR_CW or COLOR_WW : just press the ENTER button to confirm your choice
 If you have chosen COLOR SET: press the ENTER button to access the manual color settings
 RED is blinking on the display: use the DOWN and UP buttons to set the intensity of the red color
(000 = minimum, 255 = maximum)
 Press the ENTER button to confirm and to go to the next color
 GREEN is blinking on the display: use the DOWN and UP buttons to set the intensity of the green
color (000 = minimum, 255 = maximum)
 Press the ENTER button to confirm and to go to the next color
 BLUE is blinking on the display: use the DOWN and UP buttons to set the intensity of the blue
color (000 = minimum, 255 = maximum)
 Press the ENTER button to confirm
IMPORTANT: Don't forget the bar is equipped with a master dimmer. If the output seems to be too
low or if there is no light output at all, please check the MASTER DIM setting !
SLOW COLOR FADE MODE:
Used to let the projectors slowly fade from one color into another.
 Press the MODE button until 01.STATIC or xx.EFFECT (number 02 to 14 followed by EFFECT) is shown
on the display.
 Press the ENTER button to enter the configuration mode
 The actual mode (static or effect mode) is blinking on the display
 Use the DOWN and UP buttons to select 02.EFFECT (fading from one color into another) or
04.EFFECT (each color fading on and off)
 Press the ENTER button to confirm
JB SYSTEMS
®
6/16
USER MANUAL
COB-4BAR