Table of Contents
Advertisement
ENGLISH
Select one of the automatic, sound or static color modes on the master (the first COB-4BAR in the
DMX chain)
Set all the other bars in SLAVE mode
The projectors will now follow the program of the master COB-4BAR so they all work synchronously.
C. Controlled by the wireless remote controller:
To be able to use the wireless remote control, you need to enable this option in the 4BAR:
Press the MODE button until IR ACTIVE is shown on the display.
Press the ENTER button to be able to change the setting
Use the DOWN and UP buttons to enable or to disable the remote control option (ON = remote control
enabled, OFF = remote control disabled).
Press the ENTER button to confirm
Press the MODE button until SLAVE & FOOT CONTROL is shown
on the display.
Press the ENTER button to confirm
Functions:
BL: is used to switch the LEDs off/on
SP: is used to set the running speed when you are using the color
change or the color fade modes. Press this button several times to
select one of the 4 preprogrammed speeds. (Slow, medium, fast, off)
BRIGHTNESS (Master Dimmer): is used to set the General
brightness of your projectors. Press this button several times to select
one of the 4 preprogrammed brightness levels. (50%, 75%, 100%,
off)
FL: is used to activate the strobe (Flashing) mode. Press this button
several times to select one of the 4 preprogrammed flash
frequencies. (Slow, medium, fast, off)
R is used to set the intensity of the Red LED source. Press this button
several times to select one of the 4 preprogrammed brightness levels.
(50%, 75%, 100%, off). Don't forget that the brightness is also
influenced by the master dimmer ! (= BRIGHTNESS button)
G is used to set the intensity of the Green LED source. Press this button several times to select one of
the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't forget that the brightness is also
influenced by the master dimmer ! (= BRIGHTNESS button)
B is used to set the intensity of the Blue LED source Press this button several times to select one of
the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't forget that the brightness is also
influenced by the master dimmer ! (= BRIGHTNESS button)
W is used to set the intensity of the White color (Red + Green + Blue together) Press this button
several times to select one of the 4 preprogrammed brightness levels. (50%, 75%, 100%, off). Don't
forget that the brightness is also influenced by the master dimmer ! (= BRIGHTNESS button)
Pr1, Pr2, Pr3, Pr4: These buttons are used to run the built-in color chase programs. Brightness, speed
and flash rate can be adjusted with the buttons BRIGHTNESS, SP and FL
D1, D2, D3, D4: These buttons are used to run the built-in color fade programs. Brightness, speed and
flash rate can be adjusted with the buttons BRIGHTNESS, SP and FL
SA1, SA2, SA3, SA4: These buttons are used to run the built-in sound controlled chase programs.
Brightness and flash rate can be adjusted with the buttons BRIGHTNESS and FL
Note: Maximum distance between the wireless remote and the fixture = +/- 10m
D. Controlled by the LEDCON-02 Mk2:
Follow the steps below to control the bar using the
LEDCON-02 Mk2
1. Select the specific LEDCON-02 setup in the default
modes:
Press the MODE button until DEFAULTS is shown on the
display.
Press the ENTER button to go into the Defaults mode.
Use the DOWN and UP buttons till LEDCON-02 appears on
the display
JB SYSTEMS
®
9/16
USER MANUAL
COB-4BAR
Advertisement
Table of Contents
