JB Systems COB-4BAR Operation Manual page 12

ENGLISH
 Press the ENTER button
 The bar will ask you to confirm. Use the DOWN and UP buttons to select YES.
 Press the ENTER button to confirm your choice.
2. Set the correct DMX address:
 See previous chapter HOW TO SETUP to set the DMX address
 If you use the LEDCON-02 in 4CH mode you have to select DMX address 001
 If you use the LEDCON-02 in 8CH mode and you want to use the bar for the first 4 channels (first
4-bar) you have also to select DMX address 001
 If you use the LEDCON-02 in 8CH mode and you want to use the bar for the last 4 channels
(second 4-bar) you have to select DMX address 017
 For instructions on how to use the LEDCON-02 Mk2: please check the user manual of this
controller.
Important notes:
 The COB-4BAR is only compatible with LEDCON-02 Mk2, not with the LEDCON-02 !
 While used with the LEDCON-02 Mk2, the 2 power outputs (12+13) cannot be controlled, they will
be on all the time!
E. Controlled by the LEDCON-XL:
On the Ledcon-XL itself, you will have to set the UNIT ID for each of the 4 projectors of the 4-bar to
RGB
Follow the steps below to configure the COB-4BAR
1. Select the specific LEDCON-XL setup in the default modes:
 Press the MODE button until DEFAULTS is shown on the display.
 Press the ENTER button to go into the Defaults mode.
 Use the DOWN and UP buttons till LEDCON-XL appears on the display
 Press the ENTER button
 The bar will ask you to confirm. Use the DOWN and UP buttons to select YES.
 Press the ENTER button to confirm your choice.
2. Set the correct DMX address:
 See previous chapter HOW TO SETUP to set the DMX address
 If you use the LEDCON-XL in 4CH mode you have to select DMX address 001
 If you use the LEDCON-XL in 8CH mode and you want to use the bar for the first 4 channels (first
4-bar) you have also to select DMX address 001
 If you use the LEDCON-XL in 8CH mode and you want to use the bar for the last 4 channels
(second 4-bar) you have to select DMX address 033
 For instructions on how to use the LEDCON-XL: please check the user manual of this controller.
 While used with the LEDCON-XL, the 2 power outputs (12+13) cannot be controlled, they will be
on all the time!
F. Controlled by the optional foot controller:
To be able to use the foot controller, you need to enable this option in the 4BAR:
 Press the MODE button until SLAVE & FOOT CONTROL is shown on the display.
 Press the ENTER button to confirm.
General description of the foot controller:
 ROTARY Knob: is used to set the
sensitivity of the build-in microphone
for the sound controlled mode.
 MODE Switch: is used to select one
of the 3 different working modes:
COLOR, SOUND, PROGRAM
 UP & DOWN Switches: are used to
select the different program options
 BLACKOUT Switch: is used to
switch the LEDs off/on or to select
the Full On function.
JB SYSTEMS
®
10/16
USER MANUAL
COB-4BAR