HEIDENHAIN MANUALplus 620 Manual page 32

Tool The touch probes for tool measurement from HEIDENHAIN
are suited for probing tools directly on the machine. The
measurement
MANUALplus 620 has standard routines. The MANUALplus 620
automatically saves the results of measurement in a tool table.
It is also possible to measure tool wear between two machining
steps. The MANUALplus 620 automatically compensates the tool
dimensions for the subsequent operation.
With the triggering TT touch probes, the cuboid probe contact
is deflected from its resting position by contact with the
stationary or rotating tool and a trigger signal is transmitted to the
MANUALplus 620.
TT 160 New generation touch probe; signal transmission to the control
over connecting cable
TT 460 Next generation touch probe, hybrid technology: signal
transmission via radio or infrared beam (see below for fitting
transmitter/receiver unit)
Cuboid probe con- The TT tool touch probes include a disk-shaped probe contact. For
tact use with lathes, it must be replaced by the cuboid probe contact.
Transceiver unit The radio or infrared transmission is established between the TS
or TT touch probe and the SE transceiver unit.
SE 660 For radio and infrared transmission (hybrid technology);
SE 540 For infrared transmission; integration in the spindle head
SE 642 For infrared transmission; shared SE for TS and TT
The following combinations are possible:
TS 444
TS 460
TS 642
TS 740
TT 460
32
common SE unit for TS 460 and TT 460; new generation
SE 660 SE 540
- Infrared
Radio/infrared Infrared
- Infrared
- Infrared
Radio/infrared Infrared
TT 160 with a cuboid probe contact
SE 642
Infrared
Infrared
SE 660
Infrared
Infrared
Infrared