HEIDENHAIN MANUALplus 620 Manual page 11

User function
Interactive Contour
Programming (ICP)
smart.Turn
programming
TURN PLUS
MANUALplus 620
8/9 Contour definition with linear and circular contour elements
8/9 Immediate display of entered contour elements
8/9 Calculation of missing coordinates, intersections, etc.
8/9 Graphic display of all solutions for selection by the user if more than one solution is possible
8/9 Chamfers, rounding arcs and undercuts available as form elements
8/9 Input of form elements immediately during contour creation or by superimposition later
8/9 Changes to existing contours can be programmed
8/9 Machining attributes available for individual contour elements
8/9+55 C-axis machining on face and lateral surface:
– Description of individual holes and hole patterns (only in smart.Turn)
– Description of figures and figure patterns for milling (only in smart.Turn)
– Creation of freely definable milling contours
9+70 Y-axis machining on the XY and ZY planes (only in smart.Turn):
– Description of individual holes and hole patterns
– Description of figures and figure patterns for milling
– Creation of freely definable milling contours
8/9+55+ Programming of the rear face for full-surface machining with the C and Y axes
70+132
8/9+42 DXF import: Import of contours for lathe and milling operations
9 The basis is the "unit," which is the complete description of a machining block (geometry,
technology and cycle data)
9 Dialog boxes divided into overview and detail forms
9 Fast navigation between the fillable forms and input groups via the "smart" keys
9 Context-sensitive help graphics
9 Start unit with global settings
9 Transfer of global values from the start unit
9 Transfer of cutting values from technology database
9 Units for all turning and recessing operations for simple contours and ICP contours
9+55/70 Units for boring, drilling and milling operations with the C or Y axis for simple holes, milling
contours and drilling and milling patterns as well as those programmed with ICP
9+55 Special units for activating/deactivating the C axis, subroutines and section repeats
9+55/70 Verification graphics for blank and finished part and for C and Y axis contours
9 Turret assignment and other setup information in the smart.Turn program
9 Parallel programming
9 Parallel simulation
63 Automatic smart.Turn program generation with
– Automatic tool selection
– Automatic turret assignment
– Automatic calculation of cutting data
– Automatic generation of machining sequence in all working planes, also for C-axis machining
(with option 55) and Y-axis machining (with option 70)
– Automatic cutting limitation through chucking equipment
– Automatic generation of work blocks for rechucking for turning with counter spindles
– Automatic generation of work blocks for rear-face machining (with option 132)
11