HEIDENHAIN MANUALplus 620 Manual page 18

NC software There are always three control loops enabled in the basic version.
The controller unit must be designed for the corresponding
license and
enabling of number of activated control loops. Maximum numbers:
control loops
•
UEC 111: 4 control loops
•
UEC 112: 5 control loops
•
CC 6106/UEC 113: 6 control loops
•
CC 6108: 8 control loops
•
CC 6110: 10 control loops
You can find the usual SIK combinations in the following table.
Other versions are available upon request.
SIK with software license and enabling for
Control
loops
3
3
4
Enabling further Further control loops can be enabled either as groups or
control loops individually. The combination of control-loop groups and individual
control loops makes it possible to enable any number of control
loops. A maximum of 10 control loops are possible.
Control-loop groups
4 additional control loops
Individual control loops
1st additional control loop
2nd additional control loop
3rd additional control loop
4th additional control loop
5th additional control loop
6th additional control loop
7th additional control loop
18
Included options
•
Teach-In (option 8)
•
smart.Turn (option 9)
•
Thread recutting (option 11)
•
C-axis machining (option 55)
•
Teach-in (option 8)
•
Additional axis 1 (option 0)
•
Teach-in (option 8)
•
C-axis machining (option 55)
Option
77
Option
0
1
2
3
4
5
6
SIK
ID 733604-53
ID 733604-55
ID 733604-56
ID 634613-01
ID 354540-01
ID 353904-01
ID 353905-01
ID 367867-01
ID 367868-01
ID 370291-01
ID 370292-01