Table of Contents
Advertisement
STEP 4
While another person holds the Upright (17) near
the Frame (1), connect the Extension Wire (13) to
the sensor Wire (11).
Next, connect the Resistance Cable (25) to the
Lower Cable (12) in the following way:
• See drawing A. Pull upward on the metal bracket
on the Lower Cable (12), and insert the tip of the
Resistance Cable (25) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(25) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (13,11) and the Cables (25, 12)
downward into the Frame (1).
Tip: Do not pinch the wires and cables. Insert the
Upright (17) into the Frame (1). Attach the Upright
with four Screws (14) and four Washers (6).
STEP 5
I: Feed the pulse wire (28) out of the handlebar
post (17) through the top of the computer bracket.
II: Attach the handlebar (27) to the handlebar post
(17) with the Inner hex bolt (31), spring washer
(30), flat washer (34), then cover the Handlebar
Chuck Cover (32) as shown.
STEP 6
Connect all the wires (13 & 28) to the wires come
from the computer (24), and then install the com-
puter (24) onto the computer bracket on the top of
the handlebar post (17) with the cross pan head
screw (21) and flat washer (22) as shown.
Now your machine is ready for use.
A
Metallic
support
6
25
12
9
7
C
B
Metallic
25
6
support
12
9
Advertisement
Table of Contents
