Table of Contents
Advertisement
I
NSTALLATION
IBM 46xx or OCIA
1.
Turn off the host device.
2.
Plug the male 10-pin RJ45 end
of the MVC cable into the
10-pin socket on the MS3580.
3.
Connect the other end of the MVC
cable to the host device.
4.
Turn on the host device.
When the scanner first receives power, the blue LED will turn on; the
scanner will simultaneously emit a beep and flash the white LED.
Plugging the scanner into the serial port of the PC does not
guarantee that scanned information will appear at the PC. A software
driver and correct configuration setting are also required for proper
communication to occur.
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner
must meet the requirements for SELV (Safety Extra Low Voltage) according to EN/IEC
60950.
To maintain compliance with standard CSA C22.2 No. 60950/UL 60950 and norm
EN/IEC 60950, the power source should meet applicable performance requirements for
a limited power source.
Figure 9.
9
Advertisement
Table of Contents
