Installation For Ibm 46Xx Interface - Metrologic MS7320 InVista Series Installation And User Manual

I
NSTALLATION FOR
1. Turn off the host system.
2. Connect the MVC cable to the 10-pin
IBM 46xx interface jack. It is the
st
1 round opening from the left side of
the MS7320 (see figure 6).
3. Connect the other end of the MVC
cable to the host.
Before continuing verify that the MVC
cable is connected to the proper
communication jack on the scanner.
Incorrect cable connection can cause
communication problems or potential
damage to the scanner.
Plugging the scanner into the serial port of the PC does not guarantee
that scanned information will appear at the PC. A software driver and
correct configuration setting are also required for proper
communication to occur.
4. Turn on the host system.
5. Scan the Load 46xx IBM Defaults bar
code to configure the MS7320 for
RS232/IBM communication.
6. Snap on the cable cover
For additional communication
options for IBM interfaces refer to the
MetroSelect Programming Guide
( 00-02407A-1 & -2).
MLPN
Caution:
To maintain compliance with applicable standards, all circuits connected to the scanner must meet the
requirements for SELV (Safety Extra Low Voltage) according to EN 60950.
To maintain compliance with standard CSA C22.2 No. 60950-00/UL 60950 and norm EN 60950, the power
source should meet applicable performance requirements for a limited power source.
10
IBM 46 I
XX NTERFACE
Figure 6: IBM 46xx Interface
Load 46xx IBM Defaults
³ 9 9 9 9 9 5