Setting The Hdmi Setup; Hdmi; Cec Control; Setting The Surround Parameter Setup - Sherwood R-807 Operating Instructions Manual

Setting the HDMI Setup

HDMI

The HDMI connection can carry uncompressed digital
video signals and digital audio signals. Depending on
whether the digital audio signals input into the HDMI
IN are output from the HDMI MONITOR OUT of the
main unit or not, you should set the HDMI Audio Output
correctly.
Menu item Description
Disables HDMI digital audio
signals output from the HDMI
MONITOR OUT of this main unit.
AMP
Then, these signals are heard
this receiver.
Enables HDMI digital audio signals
output from the HDMI MONITOR
TV OUT of the main unit. Then,
these signals are heard from the
Note
If the HDMI Audio Output is set to "TV", no sound
input source is selected.

CEC Control

The CEC Control function allows input selection of the
connected components.
Menu item Description
On Enables the CEC Control function.
Off Disables the CEC Control function.
Setting the Surround
Parameter Setup

Height Gain

You can adjust the front height channel level as desired
(This setting is valid only when listening in Dolby Pro
Logic IIz mode).
Menu item Description
Decreases the front height
L : Low
channel level.
Outputs the front height channel
M : Mid sound with standard sound volume
level.
Increases the front height channel
H : High
level.

PANORAMA

You can extend the front stereo image to include the
imaging.
Menu item Description
On Enables the panorama effect.
Off Disables the panorama effect.

Center Width

This adjusts the center image so it may be heard only
8 steps from 0 to 7.

Dimension

towards the front or towards the rear.
The control can be set in 7 steps from -3 to +3.

Center Image

When one of the Neo:6 is enabled, you can adjust
the level of the center image so it may be heard from
11 steps from 1 to 10.
Customizing Settings
47