Daikin UATN60CGXY1 Technical Manual page 13

1) Installation Clearances
Refer diagram below for the space required around the unit. Note that:
a) All dimensions shown are in mm.
b) All space values shown are minimum clearance required for the unit.
c) Unit shown in the diagram is UATN210/240C. Other models shall follow the same clearance.
Model : UATN60/90C
Evaporator coil &
Air filter service
Evaporator coil, motor
& Air filter service
Model : UATN120/150/180/210/240/300C
Evaporator coil & motor
service, Air filter service
Evaporator coil,
air filter service
2) Cable Size
Power Cable
Model
UATN60C
UATN90C
UATN120C
UATN150C
UATN180C
UATN210C
UATN240C
UATN300C
Note:
- A main switch or other means for disconnection, having a contact separation in all poles, must be
incorporated in fixed wiring in accordance with local and national legislation.
- The unit is to be wired directly from an electrical distribution board either by a circuit breaker (preferred) or
HRC fuse.
- Fix the power supply to control module. Connect control wiring to control terminal block through the control
box's hole.
- Earth wiring must be connected.
- The power supply cord must be equivalent to H07RN-F which is the minimum requirement, and to be used
in protective tube.
Condenser
1200
air inlet
Condenser
air inlet
Electrical control circuit service &
compressor service
Condenser
1200
air inlet
Condenser
air inlet
Electrical
control circuit
service &
compressor
service
Condenser
air inlet
Condenser
air inlet
Breaker Capacity
(mm ) (A)
2
2.5 20
4 32
6 32
10 40
10 50
16 63
16 63
25 80
Condenser
air outlet
Condenser
air outlet
Over Current
Protection Switch (A)
20
32
32
40
50
63
63
80
Application Information
Condenser
air inlet
Earth Cable
(mm )
2
2.5
4
6
10
10
16
16
25
9