UAT-C series is allows for ease of transportation and installation. developed with the target of high EER. Separate Service Panels Model UAT150C UAT180C The unit is designed with two separate service panels for easy electrical box servicing. Gross EER @ 35°C 11.5...
Features UAT-C_(i) Component Features Compressor Condenser Coil High effi ciency, low noise, and hermitically sealed Condenser coils are manufactured from seamless SCROLL compressors are used in the UAT-C series inner grooved copper tubes mechanically bonded to to give a better performance. aluminium fi...
Page 7
UAT-C_(i) Features Refrigerant Circuit Electrical Control Panel The UAT-C series is designed with the ability to The control panel is protected by a panel cover operate at partial load depending on the requirement to prevent nuisance changes by unauthorized of the application. personnel.
Page 8
Features UAT-C_(i) Microprocessor Based Control The control system consists of a microprocessor controller and a user interface remote controller. The controller offers the following features: • Built in anti recycle timer to prevent compressor short cycling • Sequential control of compressor, condenser motor and evaporator motor •...
UAT-C_(i) Installation Installation Installation Guideline Safety Precautions This manual provides the procedures of installation to ensure a safe and good standard of operation for the air conditioner unit. Special adjustment may be necessary to suit local requirements. Before using your air conditioner, please read this instruction manual carefully and keep it for future reference. This appliance is intended to be used by expert or trained users in shops, in light industry and on farms, or for commercial use by lay persons.
Installation UAT-C_(i) Installation Clearances Refer diagram below for the space required around the unit. Note that: a) All dimensions shown are in mm. b) All space values shown are minimum clearance required for the unit. c) Unit shown in the diagram is UAT300C. Other models shall follow the same clearance...
UAT-C_(i) Specifi cation Guide Specifi cation Guide General Features Condenser Fan & Motor The rooftop unit shall consist of compressors, fan Condenser Motor shall be of IP55 insulation class motors, condenser coils, evaporator coil, expansion rating and is equipped with dust proof bearing. valves, refrigerant piping and electrical components.
Need help?
Do you have a question about the UAT150C and is the answer not in the manual?
Questions and answers