Rear Panel - QSC DSP-3 Hardware Manual
Digital signal processor amplifier accessory
Hide thumbs
Also See for DSP-3:
- Specification sheet (4 pages) ,
- Service bulletin (4 pages) ,
- Hardware manual addendum (1 page)
Table of Contents
Advertisement
Section 1:
Introduction-
Basic Connector & Indicator Descriptions
REAR PANEL
DATAPORT (unlabeled)- This is the "output"
DataPort.
If the DSP-3 is directly mounted on a 2-RU QSC
DataPort equipped amplifier, this connector plugs
into the amplifier's DataPort connector.
If used with 3-RU QSC DataPort equipped amplifi-
ers, the DSP-3 will need to be remotely mounted
and a male-female DataPort cable used to inter-
connect the amp & DSP-3.
If used with a non-DataPort amp (QSC or other),
this connector will not be used.
OVERALL
13
Advertisement
Table of Contents
