Setting Up The Sound And Hdmi Functions - JVC NX-T10 Instructions Manual

Setting Up the Sound and
HDMI Functions
You can change the settings of sound and HDMI functions
with the menu on the display.
1
Press and hold SET UP until the menu is shown on the
display.
2
Press ∞ (or 5) to select the item to set, then press
ENTER.
3
Press ∞ (or 5) to select the setting.
4
Press ENTER.
5
Repeat step 2 – 4 to set up other items.
Item
AUDIOOUT
HDMI CEC
DVICOLOR
DVDLEVEL
41
Remote
ONLY
You can select whether or not the audio signal from the HDMI MONITOR OUT terminal
is emitted.
TV: The audio signal is emitted from the HDMI MONITOR OUT terminal. The sound
from the System is muted.
• The System emits the audio signal according to the setting of "HDMI AUDIO" in the
Setup menu (see page 40).
AMP: The audio signal is not emitted from the HDMI MONITOR OUT terminal. The
System reproduces the sound.
You can select the usage for the HDMI CEC function. (Refer also to page 42.)
ON 1: Normally select this for using the HDMI CEC function.
ON 2: Select this if you do not want to have the System automatically turned on/off
by turning on/off the TV or external HDMI CEC compatible devices. All other available
HDMI CEC functions operate the same as when "ON 1" is selected.
OFF: Deactivates the HDMI CEC function.
You can select the settings for the picture appearance (image quality, color intensity and
black fading) on the TV connected to the HDMI MONITOR OUT terminal.
STANDARD: Normally select this.
ENHANCE: The System automatically adjusts the picture appearance.
DVD sound is sometimes recorded at a lower level than other discs and sources. You can
set the increase level for the currently loaded DVD, so you do not have to adjust the volume
when you change the source.
• This only functions for DVD Video and DVD-VR.
NORMAL: Original recording level.
MEDIUM: Output level is increased (less than "HIGH").
HIGH: Output level is increased (more than "MEDIUM").
To exit from the menu
Press CANCEL.
• The menu for settings of sound and HDMI functions
goes off if any operation is not performed for about 5
seconds.
Contents