Creating Your Own Sound Mode--User; Mode; Turningon Or Offthe Key-Touch Tone - JVC HX-Z30 Instructions Manual

Surround modes*
DANCE: Increases resonance and bass.
HALL: Acids depth and brilliance to the sound.
STADIUM: Acids clarity and spreads the sound, as in an
outdoor stadium.
SEA (Sound Effect Amplifier) modes
ROCK: Boosts low and high frequency. Good for acoustic
music.
POP: Good for vocal music.
CLASSIC: Good for classical music.
User modes
USER 1/2/3: Your individual mode stored in memory. See
"Creating Your Own Sound Mode--User
Mode" below.
OFF: The sound mode is canceled.
* Surround elements are added to the SEA elements to create a
being-there feeling in your room.
_When you turn on Sound Turbo
The sound mode is canceled.
CreatingYourOwnSoundMode--User Mode
You can change the SEA pattern to suit your preference. The
SEA paltern can be adjusted using 3 frequency ranges_BASS,
MID (middle), and TRE (treble). These changed settings can
be stored as the USER 1, USER 2, and USER 3 modes.
• There is a time limit in doing lhe following steps. If the selting
is canceled before you finish, start from step 1 again.
On the unit ONLY:
1
Select one of the
preset
sound modes.
• If you want to add surround elements into your SEA
pattern, select one of the surround modes (DANCE,
HALL, or STADIUM) before starting the procedure
below. (See "Selecting the Sound Modes" on page 10.)
2 Press SET/DISPLAY while the
selected sound mode is still shown
on the display.
SET
/DISPLAY
SER ,- n,,,
/ Ulq I
,-qRS'- '
Current level appears.
3
Adjust
the SEA
pattern.
1) Turn _ / _1 to select the
frequency range (BASS,
MID or TRE).
2) Press _ or _ to adjust
the level (-3 m +3) of the selected frequency range.
3) Repeat steps 1) and 2) to adjust the level of the other
frequency ranges.
4 Press SET/DISPLAY again.
I
u"SEP ,
SET
/DISPLAY
5 Turn I_l_l / 1_14 to select one
of the user modes (USER 1,
USER 2, or USER 3) in which
you want to store your SEA
pattern.
6
Press SET/DISPLAY again.
I,,, E I,,, 1"7 _ ,,
II II U I
The SEA pattern you have created is stored into the user
mode selected in step 5.
To useyour ownsoundmode
Select USER 1, USER 2, or USER 3 mode when using the
sound modes. See "Selecting the Sound Modes" on page 10.
When you unplug theAC power cord or ifa power
failure occurs
The setting will be erased in a few days. If this happens, set the user
modes again.
TurningOn or Offthe Key-touch Tone
If you do not want the key-touch tone to beep each time you
press a button or turn a control, you can deactivate it.
The BEEP ON indicator goes off from the display.
On the unit:
Press and hold BEEP for more
than 2 seconds.
On the remote control:
Press BEEP ON/OFF.
•
Each time you press the button, the
key-
touch tone turns on and off
alternately.
11