Audio Alarm Verification (Two-Way Voice Feature); Activation; Operator Commands - Honeywell Lyric LCP500-LC Installation And Reference Manual

ETL
Audio alarm verification has not been evaluated by Audio alarm verification has not been evaluated by Audio alarm verification has not been evaluated by Audio alarm verification has not been evaluated by ET
Audio Alarm Verification (Two Audio Alarm Ver Audio Alarm Ver Audio Alarm Ver
This feature allows the Central Station operator to listen, talk to or conduct a two-way conversation with an
individual(s) at the premises. It also assists the operator in gathering information about the nature and location
of the alarm that may be helpful in responding to police and fire departments. All Lyric Controllers are capable
of supporting the Two-Way Voice feature. The Lyric Controller does not make system announcements when the
Two-Way Voice feature is active.
If a Wi-Fi connection is being used for Two-Way Voice (AAV), sufficient bandwidth must be available.
AAV requires a continuous Wi-Fi upload/download bandwidth of 90kbps for proper operation.
•
Wi-Fi bandwidth less than 90kbps may result in degraded performance.
•

Activation

Activation
Activation Activation
Fire and CO alarms will Fire and CO alarms will prevent the Fire and CO alarms will Fire and CO alarms will
CO alarm will end an AAV session that is in progress. CO alarm will end an AAV session that is CO alarm will end an AAV session that is CO alarm will end an AAV session that is
The controller sends the "alarm message" followed by a "Listen-in-to-Follow message" (Contact ID® code 606)
to the Central Station. The Listen-in-to-Follow message causes the Central Station's digital receiver to
temporarily hold the phone line for approximately 1 minute. When the controller receives the "kissoff" from the
Central Station, indicating that the alarm message has been received, the Two-Way Voice (AAV) feature is
activated in the (default) "Listen Mode" and sirens and keypad sounds are discontinued. The controller transmits
a beep acknowledgment to the Central Station, once per second. The beep alternates between two tones and
indicates that the controller is waiting for a session command from the Central Station operator. Once a
command is issued the beep acknowledgement is discontinued, however, if a command is not issued within two
minutes the system will "time out" and the call will be terminated.

Operator Commands

Operator Commands
Operator Commands Operator Commands
The Central Station operator begins the session, which last 5 minutes, by entering one of the valid AAV
commands shown in the table below. The session may be extended 5 minutes, without changing the operating
mode, by pressing the [7] key on the touch-tone phone. Selecting another operating mode also resets the
session an additional 5 minutes. During the last minute of the 5 minute, session, the controller generates two
beeps every 30 seconds to alert the Central Station operator that the session is about to time out. The Central
Station operator may then extend the session by pressing the [7] key on the touch-tone phone. If the session is
not extended, the phone line is disconnected and the session is ended. Sessions may be ended at any time by
pressing the [9] key on the touch-tone phone. The AAV modes are described as follows:
Note: When entering AAV commands make sure the Central Station receiver has been disconnected Note:
Note: Note:
from the phone line, otherwise AAV commands may not go through.
Key Key
Key Key
1 Talk Mode: Pressing the [1] key on the touch tone phone, enables one-way voice communication
from the Central Sation to the violated premises, and allows the operator to communicate through
the controller's built-in speaker. In this mode the controller's Panic button is lit Red and the Home
button is alternately lit Red and Green.
2 VOX (Voice) Mode: Pressing the [2] key on the touch-tone phone, enables two-way voice
communications between the Central Station and the violated premises via the controller's built-in
speaker and microphone. In this mode the controller's Panic button is lit Red and the Home button is
alternately lit Red and Green.
3 Listen Mode: Pressing the [3] key on the touch-tone phone, Enables one-way audio from the violated
premises to the Central Station. The Listen Mode is the start up default mode of the voice feature and
allows the operator to listen through the controller microphone. This mode does not affect the existing
LED pattern.
7 Extends the session 5 minutes without changing its operating mode.
9 Ends the session and disconnects the phone line.
ification (Two- - - - Way Voice Feature) ification (Two ification (Two Way Voice Feature) Way Voice Feature) Way Voice Feature)
prevent the Lyric prevent the prevent the
LYNX Touch Installation and Setup Guide
System Operation (Continued) System Operation
System Operation System Operation
ET ET ETL. L. L. L.
Lyric Controller Lyric Lyric Controller Controller Controller from starting from starting an AAV session. A new Fire or from starting from starting
in progress. in progress. in progress.
Function Function
Function Function
- 25 -
(Continued)
(Continued) (Continued)
an AAV session. A new Fire or an AAV session. A new Fire or an AAV session. A new Fire or