Zone Discovery Mode; Rebooting The System - Honeywell Lyric LCP500-LC Installation And Reference Manual

Zone Discovery Mode

Zone Discovery Mode
Zone Discovery Zone Discovery Mode Mode
Zone Discover Zone Discover Zone Discover Zone Discovery mode requires Installer supervision when in use. The system is not fully operational y mode requires Installer supervision when in use. The system is not fully operational y mode requires Installer supervision when in use. The system is not fully operational y mode requires Installer supervision when in use. The system is not fully operational
for fire or life safety while Zone Discovery Mode is active. for fire or life safety while Zone Discovery Mode is active. for fire or life safety while Zone Discovery Mode is active. for fire or life safety while Zone Discovery Mode is active.
Zone discovery mode can be used to remotely view all zones that have been programmed in the system for
operation. The zones must have a response type programmed. All programmed zones will be displayed.
Enter Zone Discovery Enter Zone Discovery Enter Zone Discovery Enter Zone Discovery
1. With the System in the Installer Programming mode, select the "Test" button and then select the "Zone
Discovery" button. The "Zone Discovery" button will be highlighted indicating that the mode is active.
Exit Zone Discovery Exit Zone Discovery Exit Zone Discovery Exit Zone Discovery
1. Select the Home key and enter the Master Code. If you do not exit Zone Discovery mode manually, the
system will automatically exit zone discovery mode in approximately 1-4 minutes dependent upon the
number of zones that are programmed. The system beeps once and returns to the home screen.

Rebooting the System

Rebooting the System Rebooting the System Rebooting the System
The Reboot function allows you to restart the system if required. To reboot the system perform the following:
1. With the System in the Installer Programming mode, select the "Test" button and then select the
"Diagnostics" button.
2. The system advances to the next screen. Select the "Reboot" button. A confirmation screen appears.
3. Select "Yes". The system will restart.
Note: Note: After the reboot sequence is complete it is recommended that you perform a "Walk Test" to verify that Note: Note:
all transmitters are operational in the system.
.
Lyric Controller Installation and Reference Guide
Testing the System (Continued) Testing the System
Testing the System Testing the System
- 29 -
(Continued)
(Continued) (Continued)