Automatic Mode - Kärcher NT 611 Eco M Operating Instructions Manual

English

AUTOMATIC MODE

Plug the electric tool's power plug
into the vacuum cleaner (3)
Switch the unit on (1)
The lamp is lit - the vacuum
cleaner is in the standby mode (2)
Note:
♦ The vacuum cleaner is
automatically switched on and off
with the electric tool.
♦ The vacuuming device has a start-
up delay of up to 0.5 s and a
maximum running down time of up
to 15 s.
♦ Electrical tools of 100 - 2200 W
can be connected to the unit. See
the Technical Data page for the
electric tool's power connection
data.
NT 611 Eco M
Adapt the connection sleeve to the
electric tool's terminal connection.
Remove the pipe bend from the
suction hose
Mount the connection sleeve to
the suction hose
Connect the connection sleeve to
the electric tool
♦ The minimum volume flow is
adjusted using the rotary
switch (1).
♦ The vacuum hose cross-section
size is indicated at the scales (2).
♦ These differently sized hose
cross-sections are required to
enable adaptation to the
connection cross-sections of the
tools.
Note:
♦ If the vacuum cleaner is operated
at different locations (i.e. a tool is
plugged into the suction point), the
integrated monitoring device must
be adjusted to the connected
(dust-producing) tool. That is to
say, the user must be warned if
the minimum volume flow required
for vacuuming falls below 20 m/s.
♦ The specified minimum volume
flow in relation to the vacuum is
given on the name plate.
14