Warning Label Identification; Placing Tool In Service - Ingersoll-Rand QS511 Operation And Maintenance Manual

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll- -Rand No. 10
Always use an air line lubricator with these tools.
We recommend the following Filter- -Lubricator- -Regulator
Unit:
For USA - - No. C08- -02- -FKG0- -28
After each 40,000 cycles or each month, whichever
occurs first, lubricate the gear train with Ingersoll- -Rand
No. 67 Grease.

WARNING LABEL IDENTIFICATION

90 psig
(6.2bar/620kPa)

PLACING TOOL IN SERVICE

Ingersoll- -Rand No. 67
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by
the hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
FILTER
COMPRESSOR
(Dwg. TPD905- -1)