Advertisement
Quick Links
Advertisement
Related Manuals for Ingersoll-Rand QS Series
Summary of Contents for Ingersoll-Rand QS Series
- Page 1 16576332 Edition 2 May 2014 Air Drill QS Series Maintenance Information Save These Instructions...
-
Page 2: Product Safety Information
Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product. - Page 3 Disassembly of the Motor the Planet Gear Head Spacer (39). For Series QS05 and QS09, lightly rap the motor end of the Gear Case on a wooden work If the motor was not removed from the Housing (1) when the tool bench top to remove the three Planet Gears (37), the Planet Gear was disassembled, slide the Motor Clamp Washer (32) off the shaft Head Assembly (36) and the Planet Gear Head Spacer (39).
- Page 4 4. Wipe each Vane (27) with a light film of Ingersoll Rand No. 10 Oil Position the gasket end of the alignment dowel against the inlet and place a Vane in each slot in the Rotor. hub on the Motor Housing. Align the flats on the Cap with the 5.
-
Page 5: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Loss of Power Check air supply. For top performance, the air pressure must Low air pressure be 90 psig (6.2 bar/620 kPa) at the inlet. Clean the Inlet Bushing Screen using a clean, suitable cleaning Plugged Inlet Bushing Screen solution. - Page 6 Notes...
- Page 7 Notes...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...