Advertisement
Advertisement
Table of Contents
Related Manuals for Ingersoll-Rand QP Series
Summary of Contents for Ingersoll-Rand QP Series
- Page 1 16572679 Edition 2 May 2014 Air Drill QP Series Maintenance Information Save These Instructions...
-
Page 2: Product Safety Information
Product Safety Information WARNING Failure to observe the following warnings, and to avoid these potentially hazardous situations, could result in death or serious • injury. • Read and understand this and all other supplied manuals before installing, operating, repairing, maintaining, changing accessories on, or working near this product. - Page 3 For Series QP15 and QP20, lightly rap the motor end of the Gear Cylinder (13). Case on a wooden work bench top to remove the three Planet Remove the Vanes (16) from the Rotor. Gears (26), the Rotor Pinion (27), the Planet Gear Head Support the Front End Plate Assembly (17), as near the rotor body Assembly (25) and the Planet Gear Head Spacer (28).
- Page 4 applied. Refer to Dwg. TPA1740. To increase the gap, support the that contacts the outer ring of the Bearing, press the Bearing into End Plate and lightly tap the rotor shaft with a plastic hammer; to the Gear Case against the Bearing Stop. For Series QP05, QP09, QP15, QP20 and QP38, insert the Planet decrease the gap, press the Bearing farther onto the rotor shaft.
-
Page 5: Troubleshooting Guide
Troubleshooting Guide Trouble Probable Cause Solution Loss of Power Low air pressure Check air supply. For top performance, the air pressure must be 90 psig (6.2 bar/620 kPa) at the inlet. Plugged Inlet Bushing Screen Clean the Inlet Bushing Screen using a clean, suitable cleaning solution. - Page 6 Notes...
- Page 7 Notes...
- Page 8 ingersollrandproducts.com © 2014 Ingersoll Rand...
Need help?
Do you have a question about the QP Series and is the answer not in the manual?
Questions and answers