Installing The Awg Software - Tektronix AWG5000 Series Manual

Arbitrary waveform generators

Hide thumbs Also See for AWG5000 Series:

Table of Contents

Installing the AWG Software

This software is factory installed on the instrument hard disk. This software

contains the instrument firmware and the other files needed to operate the instru-

ment. If you need to reinstall this software, do these steps:

NOTE.

If you are rebuilding the complete contents of the hard disk, you

must restore the Windows operating system before you install the product

software. See the Operating System Restore DVD that was shipped with

your AWG5000 or AWG7000 Series generator for instructions on how to

restore the operating system.

If you are only reinstalling the production software, proceed with step 1.

1. If the keyboard and the mouse are not installed, connect them to the instrument

(the standard-accessory keyboard and mouse plug into the USB connector). If

connecting PS2 keyboard and mouse, first shut down the instrument.

2. Power on the instrument to start Microsoft Windows.

3. Insert the AWG5000 and AWG7000 Series Product Software compact disc into

the CD drive of the instrument.

4. The installer starts automatically from the CD-ROM.

5. When "Welcome to the InstallShield Wizard for Tektronix AWG Software"

appears, click Next.

AWG5000 and AWG7000 Series Product Software

Table of Contents

Do you have a question about the AWG5000 Series and is the answer not in the manual?

Awg7000 series