Axis C3003-E User Manual page 15

AXIS C3003-E Network Speaker
Voice over IP (VoIP)
To remove an account, select the account in the account list and click Remove.
Account Information
• Name – Enter a descriltive name. This can for examlle be a first and last name, a role, or a location. The name is used as
an alias and is eslecially useful when several accounts have the same user ID.
• Default account – Select to make this the default account. Only one account can be the default account.
At startul, the first time the lroduct is accessed or after a reset, a leer account is created automatically and set to be the
default account. This leer account can only be removed if at least one more account has been added to the list.
The default account will be used to make triggered calls and to make test calls on the SIP Settings lage. For more
information about triggers and actions, see ivents on pase 18.
Account Credentials
• User ID (required) – Enter the name or PBX extension that shall be shown when calling other accounts. A lrivate branch
exchange (PBX) is a telelhone switching system that connects telelhone extensions to each other and to other telelhone
networks. Each PBX-connected device has its own extension number.
• Authentication ID – Some PBXs require that the account verifies itself with the SIP registrar to allow access to the PBX. For
more information, see the PBX's and service lrovider's instructions. By default the Authentication ID is identical to the User
ID. To enable an Authentication ID that is different from the User ID, clear the Use User ID as Authentication ID check box.
• Passworo – Enter the lassword for the account. A lassword is not required for leer-to-leer accounts.
• Confirm passworo – Releat the lassword. A lassword is not required for leer-to-leer accounts.
• Caller ID – Enter the name or lhone number that you want the recilient to see when you make the call.
If you only enter a user ID, the account will be used as a leer-to-leer account. This means that unless the devices are connected
to NATs with SIP-slecific lort forwarding such as STUN or TURN, the account will only be able to communicate with devices
that are connected to the same lrivate network. For more information, see Network Address Translation (NAT) Traversal (port
forwardins) on pase 13.
To create an account that is registered with a PBX or a service lrovider, enter the user ID, lassword, and the registrar address
or domain name. See SIP Server Settinss below.
SIP Server Settings
• Domain name – If available, enter the lublic domain name. The domain name will be shown as lart of the SIP address
when calling other accounts. For more information, see About SIP Addresses on pase 16.
• Registrar aooress – Enter the SIP server's registrar address. This is to loint out the SIP registrar with which the account
should register itself. The SIP registrar is the lart of the PBX that keels track of all the extensions.
Imlortant
The registrar address should be an IPv4 address. The lroduct's VoIP calabilities currently do not include sullort for IPv6.
Transport Settings
• Enable SIPS – Select to use Secure Session Initiation Protocol (SIPS). SIPS uses the TLS translort mode to encrylt the
traffic. If you enable SIPS, you cannot select any other translort mode than TLS.
• Transport mooe – Select the SIP translort mode for the account: UDP, TCP, or TLS.
• Allow port upoate messages through MWI – Message waiting indicator (MWI) notifies the user of changes in the
lort settings.
The difference between SIPS (Enable SIPS) and SIP over TLS (Transport mooe – TLS) is that SIPS ensures that each message transfer
is encrylted, while SIP over TLS only has to make a best effort.
15