Table of Contents
Advertisement
Ejecting a PC card
Critical Point
•
When you remove a PC card attached with a cable, do not pull the cable connected to the PC
card or it will result in failure.
•
When you remove a PC card, follow the procedure below or it will result in failure.
•
Some PC cards require shutting down when you remove them. Consult with the manual of the
PC card.
1
Click the
icon (Safety Remove Hardware) in the lower right corner of the screen
(notification area where a clock is displayed).
Critical Point
•
Don't eject the PC card by clicking the Stop button in the Safety Remove Hardware dialog box
that appears when you double-click the
corner of the screen (notification area where a clock is displayed). Doing so may cause your
computer to become unstable.
2
Click " XXXXXXXX can be removed safely."
XXXXXXXX refers to the name of the PC card inserted.
Critical Point
•
If the message, "The device "General-Purpose Volume," cannot be stopped now. Carry out the
steps later again to stop the device" appears, click OK, check to be sure that the PC card is not
being accessed, and then perform the above steps all over again, starting with step 1.
• A PC card may be quite hot right after use. Wait for a while before
removing a PC card after Step 3, to avoid burning your fingertips.
• When you remove a PC card, do not insert your finger into the PC
card slot to avoid cutting your fingertips.
icon (Safety Remove Hardware) in the lower right
39
Advertisement
Table of Contents
