Capturing Screenshots; Copying Screenshots To A Computer; Troubleshooting; My Device Will Not Acquire Gps Signals - Garmin AQUAMAP 10x2 Series Owner's Manual

bitmap (.bmp) file. You can transfer the screenshot to your computer. You can
also view the screenshot in the image viewer.

Capturing Screenshots

1 Insert a memory card into the card slot.
2 Select Settings > Preferences > Screenshot Capture > On.
3 Go to a screen you want to capture.
4 Hold HOME for at least six seconds.

Copying Screenshots to a Computer

1 Remove the memory card from the AQUAMAP, and insert it into a card
reader that is attached to a computer.
2 From Windows Explorer, open the Garmin\scrn folder on the memory
card.
3 Copy a .bmp file from the card and paste it to any location on the
computer.

Troubleshooting

My device will not acquire GPS signals

If the device is not acquiring satellite signals, there could be a few causes.
If the device has moved a large distance since the last time it has acquired
satellites or has been turned off for longer than a few weeks or months, the
device may not be able to acquire the satellites correctly.
• Ensure the device is using the latest software. If not, update the device
software.
• Make sure the device has a clear view of the sky so the antenna can
receive the GPS signal. If it is mounted inside of a cabin, it should be close
to a window so it can receive the GPS signal.
96

My device will not turn on or keeps turning off

Devices erratically turning off or not turning on could indicate an issue
with the power supplied to the device. Check these items to attempt to
troubleshoot the cause of the power issue.
• Make sure the power source is generating power.
You can check this several ways. For example, you can check whether
other devices powered by the source are functioning.
• Check the fuse in the power cable.
The fuse should be located in a holder that is part of the red wire of the
power cable. Check that the proper size fuse is installed. Refer to the label
on the cable or the installation instructions for the exact fuse size needed.
Check the fuse to make sure there is still a connection inside of the fuse.
You can test the fuse using a multimeter. If the fuse is good, the multimeter
reads 0 ohm.
• Check to make sure the device is receiving is at least 10 V, but 12 V is
recommended.
To check the voltage, measure the female power and ground sockets of
the power cable for DC voltage. If the voltage is less than 10 V, the device
will not turn on.
• If the device is receiving enough power but does not turn on, contact
Garmin product support at support.Garmin.com.

My device is not creating waypoints in the correct location

You can manually enter a waypoint location to transfer and share data
from one device to the next. If you have manually entered a waypoint using
coordinates, and the location of the point does not appear where the point
should be, the map datum and position format of the device may not match
the map datum and position format originally used to mark the waypoint.
Position format is the way in which the GPS receiver's position appears on
the screen. This is commonly displayed as latitude/longitude in degrees and
minutes, with options for degrees, minutes and second, degrees only, or one
AQUAMAP™ 10x2/12x2 SERIES