Table of Contents
Advertisement
Operating Instructions
WARNING: Keep your fingers and hands away
from the nip point while the machine is running.
They could be trapped and crushed in the rollers.
Clothing, jewelry, and long hair could be caught in
the rollers and pull you into them.
4.
Release the card and ensure that the film and
card are being pulled into the laminator.
The card will guide the film into the rollers.
5.
After the threading card exits the laminator, set
the roller pressure handle to Release.
6.
Press the STOP button.
7.
Separate the release liner from the card.
8.
Pull the film up to the take-up core and tape it to
the core.
9.
Replace the safety shield and feed table.
Refer to Safety Shield Removal and Installation and
Feed Table Removal and Installation in this section.
10.
Check the film alignment and adjust the tension
as needed.
See the Film Alignment section in this chapter.
W
PSA F
EBBING
ILMS
Refer to General Webbing Instructions before
performing the following procedure.
Note: These instructions are for webbing laminating
and mounting films for decaling. The top supply shaft
is used for laminating films and the bottom supply
shaft is used for mounting film or kraft paper. If you
are not applying mounting film to a laminate, kraft
paper should be used on the bottom supply shaft to
prevent adhesive from sticking to the rollers.
Mounting adhesive
Fig 5-15. Web Configuration with PSA Film and Mounting
Adhesive.
Kraft paper
Fig. 6-16. Web Configuration with PSA Film and
Kraft Paper.
56FM
Page 6-9
Advertisement
Table of Contents
