Table of Contents
Advertisement
Mount
Adhesive
Fig. 25
Mount
Adhesive
Fig. 26
Mount
Adhesive
Fig. 27
34
WEBBING PSA FILM/ MOUNT
ADHESIVE USING THREADING
CARD
PSA
The laminator should be cool to the
Film
touch before proceeding.
1. Turn the Power ON/OFF to on
2. Load the rolls of film as
3. Remove the safety shield and
3. Pull the top roll of film down
4. Place one piece of masking tape
5. Make two full wraps around the
PSA
Film
7. Pull the mount adhesive up
8. Use a threading card to push the
9. Pivot the table back to it's
10. Replace the safety shield.
11. Use the main roller pressure
12. Set speed to 3 or less. Ensure
PSA
13. From the rear of the machine,
Film
14. Once the web has entered the
15. Press the stop (
16. Open the main roller nip.
17. Now refer to the section
(I).
illustrated in Figure 25. Ensure
no brake tension is applied to the
film shafts.
pivot the feed table down.
Preliminary
under the idler bar and up to the
upper front rewind tube.
in the center of the film and
secure to the rewind tube.
rewind tube, then carefully
score the laminate without
cutting the release liner. Pull the
laminate down allowing it to
drape over the upper heat roller
(Figure 25).
towards the film draped over the
upper heat roller (Figure 26).
two materials through the heat
roller nip.
feeding position while ensuring
the threading card is on top of
the feed table (Figure 27).
handle to bring the main roller to
initial contact with the threading
card.Set speed to 3 or less.
foward ( ) is selected and
press the start (
) button.
guide the web over the chill idler,
if installed, and through the pull
rollers.
pull roller nip, use the pull roller
pressure handle to close the pull
roller nip.
) button
Once the threading card has
completely exited the pull
rollers,.
entitled START LAMINATING .
I
Copy
Advertisement
Table of Contents
