Table of Contents
Advertisement
GBC 3064WF
Mount
Adhesive
Figure 22
REWIND TUBE
Mount
Adhesive
Figure 23
Mount
Adhesive
Figure 24
© 2005 General Binding Corporation
REWIND TUBE
PSA
Film
PSA
Film
REWIND TUBE
PSA
Film
CHILLED ROLLER
HEAT ROLLER
Operation Manual
Webbing PSA Film/Mount Adhesive Using
Threading Card
The laminator should be cool to the touch before
Proceeding.
1. Turn the Power ON
/OFF
2. Load the rolls of film as illustrated in (Fig. 22).
Ensure no brake tension is applied to the film
shafts.
3. Pull the top roll of film down under the idler bar
and up to the upper front rewind tube.
4. Place one piece of masking tape in the center of
the film and secure to the rewind tube.
5. Make two full wraps around the rewind tube,
and then score the laminate without cutting the
release liner. Pull the laminate down allowing it
to drape over the upper roller (Fig. 22).
6. Pull the mount adhesive up towards the film
draped over the upper heat roller (Fig. 23).
7. Stick the mount adhesive to the exposed
adhesive of the upper roller.
8. Pivot the table back to its feeding position while
ensuring the threading card is on top of the feed
table (Fig. 24).
9. Use a threading card to push the two materials
through the heat roller nip
10. Lower the main heated roller to bring the main
roller into initial contact with the threading card.
Ensure front is selected and press the foot
switch.
11. From the rear of the machine, guide the web
over the chill idler, if installed, and through the
pull rollers. Once the web has entered the pull
roller nip, close the pull roller nip.
12. Press the "STOP" (
threading card has completely exited the pull
rollers and adjusts the film web tension using as
little tension as possible.
13. Now refer to the section titled "START
LAMINATING".
to On
) button when the
Page 17
Hide quick links:
Advertisement
Table of Contents
