Installation - GBC Falcon 60+ Operation Manual

Ce laminator

Hide thumbs Also See for Falcon 60+:

Table of Contents

Operations Manual

Installation

1. Shipping damage should be brought to the imme-

diate attention of the delivering carrier.

2. With assistance, carefully roll the laminator into posi-

tion over flat and even surfaces.

3. The laminator should be positioned to allow exiting film

to flow freely to the floor (Figure 3) or a work table.

Accumulation of laminate immediately behind the lami-

nator as it exits the equipment may cause the film to

wrap around the pull rollers, resulting in a "jammed"

condition.

4. Avoid locating the laminator near sources of heat or

cold. Avoid locating the laminator in the direct path of

forced, heated or cooled air.

5. Leveling of the machine is a customer option. If you

choose not to level the laminator and encounter output

problems, please level the machine and try your

application again before calling for technical support.

Resting the laminator on the leveling pads prevent

the machine from rolling during set up, operation or

servicing. (Figure 4)

6. Connect the attachment plug provided with the

laminator to a suitably grounded outlet. AVOID

CONNECTING OTHER EQUIPMENT TO THE

SAME BRANCH CIRCUIT TO WHICH THE LAMI-

NATOR IS CONNECTED, AS THIS MAY RESULT

IN NUISANCE TRIPPING OF CIRCUIT BREAKERS

OR BLOWING FUSES.

60+ (-1)

FALCON

Fig 3

x 4

Fig 4

Page 15

Table of Contents