Serial Configuration; Configuration Bar Codes; Resetting Standard Product Defaults - Datalogic BC9030 Quick Reference Manual

Serial Configuration

By connecting the BC9030-BT-BP to a PC through an RS-232 or USB-COM
interface cable it is possible to send configuration strings from the PC to
BC9030-BT-BP.

Configuration Bar Codes

Link the cradle and the reader using the procedures described in the Power-
Scan™ PM9500 Quick Reference. Once the pairing is complete, you can config-
ure the BC9030-BT-BP cradle by reading configuration bar codes in this
manual.
To configure the BC9030-BT-BP using the PowerScan™ PM9500 reader
(paired to the cradle with the Bind command), follow the procedure according
to the interface selected.

Resetting Standard Product Defaults

Reference the PRG for a listing of standard factory settings. If you aren't sure
what programming options are in your reader, or you've changed some
options and want the factory settings restored, scan the
Default Settings
rently active interface to the current configuration.
NOTE
CAUTION
To change the defaults refer to the PowerScan™ 9500 PRG, or to the Datalogic
™
Aladdin Configuration program, both downloadable from the Datalogic web-
site.
Quick Reference Guide
bar code below to copy the factory configuration for the cur-
Factory defaults are based on the interface type. Configure the reader
for the correct interface before scanning this label.
Standard Product Default Settings
Scanning this bar code will RESET all settings for the PowerScan
PM9500. Any customized settings that may have been applied to the
reader will be lost.
BC9030-BT-BP Configuration
Standard Product
™
7