Cli Monitor Commands; Table 5: Cli Monitor Command Contexts - Alcatel-Lucent 7450 ESS-12 Configuration Manual

CLI Monitor Commands

Monitor commands display specified statistical information related to the monitor subject (such as
filter, port, QoS, router, service, and VRRP) at a configurable interval until a count is reached. The
CLI monitor commands are found in the
The monitor command output displays a snapshot of the current statistics. The output display
refreshes with subsequent statistical information at each configured interval and is displayed as a
delta to the previous display.
The
<Ctrl-c>
cannot be saved. You must enter the command for each monitoring session. Note that if the
maximum limits are configured, you can monitor the statistical information for a maximum of 60
* 999 sec ~ 1000 minutes.
The CLI monitor command contexts are listed in

Table 5: CLI Monitor Command Contexts

card
ccag
cpm-filter
filter
lag
management-
access-filter
port
qos
router
service
Page 26
keystroke interrupts a monitoring process. Monitor command configurations
Command
Enables CCAG port monitoring for traffic statistics.
Monitor command output for CPM filters.
Enables IP and MAC filter monitoring at a configurable interval
until that count is reached.
Enables Link Aggregation Group (LAG) monitoring to display
statistics for individual port members and the LAG.
Enables management access filter monitoring.
Enables port traffic monitoring. The specified port(s) statistical
information displays at the configured interval until the
configured count is reached.
Enables scheduler statistics monitoring per customer multi-
service-site or on a per SAP basis.
Enables virtual router instance monitoring at a configurable
interval until that count is reached.
Monitors commands for a particular service.
root>monitor
Table
Description
7450 ESS OS Basic System Configuration Guide
context of the CLI tree.
5.
Page
90
110
112
117
118
120
122
125
150