Noise Emissions Warranty; Tampering With The Noise Control System Is Prohibited - Sullair 1600H User Manual

NOISE CONTROL
6.1 NOISE EMISSIONS
WARRANTY
Sullair warrants to the ultimate purchaser and each
subsequent purchaser that this air compressor was
designed, built and equipped to conform at the time
of sale to the first retail purchaser, with all applicable
U.S. E.P.A. and/or any Federal, State or Local noise
control regulations.
This warranty is not limited to any particular part,
component, or system of the air compressor. Defects
in the design, assembly, or in any part, component,
or system of the compressor which, at the time of
sale to the first retail purchaser, caused noise
emissions to exceed Federal standards are covered
by this warranty for the life of the air compressor.
6.2 TAMPERING WITH THE
NOISE CONTROL SYSTEM IS
PROHIBITED
Federal Law prohibits the following acts or the
causing thereof:
1. The removal or rendering inoperative by any
persons, other than for purposes of mainte-
nance, repair, or replacement, of any device
or element of design incorporated into any
new compressor for the purpose of noise
Section 6
control prior to its sale or delivery to the ulti-
mate purchaser or while it is in use.
2. The use of the compressor after such device
or element of design has been removed or
rendered inoperative by any person.
Among those acts included in the prohibition against
tampering are the acts listed below:
1. Removal or rendering inoperative any of the
following:
a. Engine exhaust system or parts thereof
b. Compressor air intake system or part thereof
c. Enclosure of part thereof
2. Removal of any of the following:
a. Vibration isolators
b. Control silencer
c. Floor panel
d. Fan shroud
e. Acoustical materials including fiberglass
foam or foam tape
3. Operation with canopy doors open for any
purpose other than starting, stopping, adjust-
ment, repair, replacement of parts or mainte-
nance.
1600C LP USER MANUAL
69