Maintenance Every 100 Hours; Maintenance Every 1000 Hours; Maintenance Every 1500 Hours; Parts Replacement And Adjustment Procedures - Sullair 1600H User Manual

SECTION 5
5.9 MAINTENANCE EVERY 1000
HOURS
Perform the following after every 1000 hours of
operation:
1. Clean the return line orifice and strainer.
2. Repack the wheel bearings on wheel-
mounted units.
5.10 MAINTENANCE EVERY 1500
HOURS
When using Sullair AWF, change the compressor
fluid and replace the fluid filter element. Refer to
PARTS REPLACEMENT AND ADJUSTMENT
PROCEDURES on page 59.
5.11 PARTS REPLACEMENT AND
ADJUSTMENT
PROCEDURES
C F
OMPRESSOR LUID
Warm-up the compressor for 5 to 10 minutes to
warm the fluid. Shut the compressor off and relieve
all internal pressure before proceeding. Drain the
fluid by opening the appropriate drain valve located
in the frame at the front of the machine. Close the
valve when draining is complete. Change the
compressor fluid and replace the fluid filter element.
For element replacement see procedure for servicing
the fluid filter in this section. Fill the receiver tank with
fluid according to Lubrication - Compressor on page
43.
R G L
UNNING EAR UBRICATION
Refer to Figure 5-1. An inspection of the running gear
should be made on a routine basis. On four-wheel
steerable running gear models, front-axle pivot joints
and rod ends are fitted with grease zerks which
should be lubricated every six months.
C P
HANGE ROCEDURE
1600C LP USER MANUAL
Figure 5-1: Running Gear Lubrication
WHEEL BEARING LUBRICATION
Refer to Figure 5-2. Proper lubrication is essential to
the proper functioning and reliability of your portable
compressor axle. Wheel bearings should be
lubricated at least once every 12 months, or more
frequently to help insure proper performance. Use
wheel bearing grease that conforms to military
specification MIL-G-10924 or a high temperature
wheel bearing grease such as lithium complex NLGI
Consistency #2.
If your axle is equipped with the E-Z Lube feature,
the bearings can be periodically lubricated without
removing the hubs from the axle. This feature
consists of axle spindles that have been specially
drilled and fitted with a grease zerk in their ends.
59