Instructions Of Use; On/Off Mode - Sawo STN-30-1/2 Manual

Instructions of Use

There are four different operation modes in the unit: Off, On, Standby and Drain. The
user can easily switch between different modes, making the steam bathing more conve-
nient with less energy consumption.
To use steam room the control unit needs to be in the On mode. In the On mode, the
steamer is active, the temperature in the steam room will be kept in the preferred, set
temperature, with occasional discharge of steam.
However, if the steam room is not used constantly, the generator can be set to Standby
mode. The water in the tank is kept warm, with minimal energy usage. The generator
is able to produce steam shortly after the unit is switch back to On mode for the conve-
nience of the users.
More details about the different modes and how to move between them can be found in
the text and graph following.
Power
Standby
Down

on/off Mode

on/off Mode
When the power switch is turned "On" the software versions of the control board and
the user interface will be displayed for 1 second each. Then the control unit will go to
"Off" mode. In the "Off" mode, the display is blank.
The auto drain can be disabled or enabled in the "Off" mode. Press and hold the Up
button, then press the Power button. The display will show "Adr oFF" or "Adr on" as
feedback.
on Mode
For "On" mode press "Power" button.
First, the set steam room temperature is displayed blinking for 5 seconds. Then the user
can change the following settings; session time, temperature and fan (not all the models
have the same features), by pressing the corresponding button in the control unit. The
up and down arrow buttons can be used to increase and decrease the values.
If no buttons are pressed for 10 seconds, the set temperature for the steam room will
be displayed.
When the session time expires, the control unit will go to the "Standby" mode.
Cabin lights/Dimmer
Fan/Scent pump
Up
Temp/Timer
ENGLISH
5