Installing Control Unit - Sawo STN-30-1/2 Manual

Installing Control Unit

SAWO Steam Control sets the temperature of your steam room. Mount the steam control
unit on an accessible area outside the steam room. It is recommended not to place the
steam control near to showers or similar wet places.
Never attempt to modify or to fix the steam control. Ask your licensed technician or your
nearest service centre for repair.
Before installation mains supply of the generator must be switch off from the circuit
breaker.
Installation Instructions
Check the most suitable area to place your steam generator control. The control and the
steam generator should be accessible for the user and maintenance. Do not install the
control unit inside the steam room! The cable of the control is 7,5 meters.
Mount the control in the wall, according to the specifications given below. Follow illustration.
A
160 mm
C
noTe!
If the control is attached to a concrete wall,
provide a control holder or equivalent to
mount the control into it.
B
84 mm
Contact your SAWO distributor
Wall
oPTIonal
Interface Holders
Rectangle
Oval
ENGLISH
19