Installing The Touch Unit On A Whiteboard; Turn On The Projector; Display The Installation Pattern - Epson Brightlink 695Wi+ Installation Manual

Installing the Touch Unit on a whiteboard

Follow the steps below to install the Touch Unit on a whiteboard. Some menus may differ slightly from the
illustrations, but the installation instructions are the same.
❏
There are magnets built in to the back of the Touch Unit. Typically, the Touch Unit
should be installed by attaching the magnets to the screen or whiteboard.
❏
If the Touch Unit cannot be attached with the magnets, use commercially available
M4 screws (×3).
❏
Install the Touch Unit on a flat, smooth, unwarped surface. If there is unevenness
on the screen surface of more than 0.2 inch (5 mm) in any direction, your fingers
may not be detected and finger touch operations may not be performed correctly.
A

Turn on the projector

B

Display the installation pattern

1. Press the Menu button on the remote control or the projector control panel.
2. Select Easy Interactive Function from the Extended menu.
Remote Control
Remote Control
27
Control Panel
Control Panel