Dell Latitude D500 Installing And Configuring page 14

Save and close any open files, exit any open
2
programs, and then shut down the computer.
If the computer is connected to a docking device
3
(docked), undock it. See the documentation that
came with your docking device for instructions.
Disconnect the computer from the electrical
4
outlet.
Wait 10 to 20 seconds, and then disconnect any
5
attached devices.
Remove any installed PC Cards and the battery.
6
NOTICE: Handle components and cards by their edges,
and avoid touching pins and contacts. Ground yourself by
touching a metal connector on the back of the computer.
Continue to ground yourself periodically during this
procedure.
Open the display approximately 180 degrees.
7
Use a small flat-blade screwdriver or plastic scribe
8
to lift the notched right edge of the center control
cover, and pry the cover loose from the bottom
case.
Remove the two screws from the top of the
9
keyboard.
Use the pull-tab to pull the keyboard up and out
10
(toward the display) of the bottom case.
18
Installing and Configuring the Mini PCI Card