Table of Contents
Advertisement
December 22, 2005
Dismounting the Array
To dismount the Array, place your fingers so as to increase the space between the Array and the mounting plate at
the positions indicated by the decals on the mounting plate—these are aligned with IAPs (radios) abg1 and abg3, as
indicated on the clock-face of the Array.
P
U
OWERING
P THE
When powering up, the Array follows a specific sequence of LED patterns showing the boot progress, and following
a successful boot will provide extensive status information. The normal boot sequence is as follows:
1. The green status LED will light first, showing a steady flashing while the unit boots. In the event of a boot
failure, this LED will change to flashing red.
2. The Ethernet Link/Activity LEDs on the underside of the Array will light for those ports connected to the
network.
3. All IAP radio LEDs will light simultaneously.
4. While the Array is booting, a sequential LED pattern will cycle through all the radio LEDs.
5. When the Array completes boot, the status LED will show a steady green, and all radio lights will show the
current state of those radios.
AIWS-UM-4003-01
a11
abg4
a10
a9
a8
abg3
a7
Figure 2-24. IAP Positions (WFX-3900)
W
LAN A
IRELESS
RRAY
a12
a1
abg1
a2
a3
a4
abg2
a5
a6
Chapter 2: Installation
2-21
Advertisement
Table of Contents
