Table of Contents
Advertisement
December 22, 2005
iap global_settings
Description
Syntax
AIWS-UM-4003-01
Makes global configuration changes to all Integrated Access Point (IAP) radio
interfaces—available from the config-interface command mode.
This command allows configuration changes to all IAP interfaces. Other global settings
can be made for specific groups of IAPs by using one of the below parameters in the
interface IAP command mode:
• iap number: Configuration for a specific IAP. The prompt will change to: IAP number
(config-iap-a12)#
• global_a_settings: Common configuration for all 802.11a IAPs. The prompt will
change to: (config-iap-global-a)#
• global_bg_settings: Common configuration for all 802.11b/g IAPs. The prompt will
change to: (config-iap-global-bg)#
• global_settings: Common configuration for all IAPs. The prompt will change to:
(config-iap-global)#
iap global_settings {all_down | all_up | [no] rogue_detect [ on |
off | add <ssa> {approved | known} | del <ssd> | list ] |
auto_channel [no][power_up [ on | off ] | schedule [<ts>]] | long-
retries <lrl> | short-retries <srl> | cellsize {small | medium |
large} | rx-threshold <thresrx> | tx-power <powertx> | beacon-
rate <brate> | beacon-dtim <bdtim> | inactive-time <at> | reauth-
period <ht> | led {disable | enable {iap_up | associated}} |
led_activity {beacon | tx_data | rx_data | tx_mgmt | rx_mgmt |
broadcast | probe_req | assoc}}
Chapter 5: Command-Line Interface
5-17
Advertisement
Table of Contents
