Table of Contents
Advertisement
Alarm Management
③ Select the warning area. You can add 4 warning areas at most.
④ Draw the warning area of the intrusion detection. Refer to the interface as shown below.
Check "Draw Warning Area" and then click around the area where you want to set as the
warning area in the image (the warning area should be a closed area). Uncheck the "Draw
Warning Area" if you finish the drawing. Click "Clear" button to delete the warning area.
⑤ Click "Apply" to save the settings.
⑥ Click "Processing Mode" to go to the alarm handling configuration interface of intrusion
detection.
Intrusion Detection Alarm Handling Configuration:
① Click Start Settings Alarm Intelligence Alarm Intrusion Detection to go to the
following interface.
68
DVR User Manual
Advertisement
Table of Contents
