Installing The Grass Deflector; Checking The Mower Adjustment - Toro TimeCutter SW series Setup Instructions

Figure 9
3. Route the wire harness to the right side of the
machine and push the plastic connector into the
seat frame hole (Figure
Figure 10
1. Plastic connector in seat
frame hole
g027695
g027695
10).
1 2
g028383
g028383
2. Wire harness
6
Installing the Grass
Deflector
Parts needed for this procedure:
1 Grass deflector (if not installed)
Procedure
If the grass deflector is not installed, remove it from
the packaging and install it onto the mower deck.
Refer to your Operator's Manual for the correct
procedure to install the grass deflector.
7
Checking the Mower
Adjustment
No Parts Required
Procedure
Adjust the side-to-side level and the front-to-rear blade
slope. Use the relevant procedures in the Operator's
Manual to verify that the deck is level, and make any
adjustments as necessary. Refer to the Operator's
Manual for more information.
6