Installing The Seat Assembly - Toro TimeCutter SW series Setup Instructions

B. Place the seat onto the seat pan, aligning
the attached seat bolts with the front
keyholes, and slide the seat back.
C. Secure the seat to the seat pan using 2 hex
bolts and 2 washers
Figure 7
1. Flange-hex bolt (2)
2. Bolt (5/16 x 1 inch) and
washer (2)
3. Seat assembly
(Figure 7).
g213797
4. Bottom cushion
5. Seat pan
6. Front keyhole
5
Installing the Seat
Assembly
Parts needed for this procedure:
1 Seat assembly
1 Seat rod
2 Hairpin cotters
2 Spacers (certain models only)
Procedure
1. Install the seat assembly to the frame with
the seat rod, 2 hairpin cotters, and 2 spacers
(certain models only) as shown in
1. Seat assembly
2. Spacers
2. Connect the seat switch
5
Figure
Figure 8
3. Hairpin cotter
4. Seat rod with hairpin cotter
installed
(Figure 9).
8.
g027723