Table of Contents
Advertisement
Setup
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to identify parts used for assembly.
DESCRIPTION
Grass deflector
Spring
Bolt, 3/8 x 3-1/2 inch
Locknut, 3/8 inch
Belt, PTO Drive
Belt, Mower Drive
Pulley box assembly
Operator's Manual
Warning
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
Never put your hands or feet under the mower.
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to Off and rotate the ignition key to Off.
Also remove the key and pull the wire off the
spark plug(s).
Installing the Grass Deflector
on 132cm Mowers
1. Place the springs into the brackets on mower with the
hooked ends over the raised back (Fig. 2).
2. Align the grass deflector with the holes in the brackets
and the spring straight end in the space under the hinge
and above the deflector (Fig. 2).
3. Secure the deflector to the bracket with 2 bolts
(3/8 x 3-1/2 inch) and 2 locknuts (3/8 inch) (Fig. 2).
QTY.
1
2
Installing the grass deflector on 132cm mowers
2
2
1
Installing the mower
1
1
1
Read before operating
4. Lift grass deflector and check that it is spring loaded
and pivots freely to the full down position.
Important
Grass deflector must be spring loaded in the
down position. Lift the deflector up to test that it snaps
down to the full down position.
5
1. Bracket
2. Spring hook end
3. space for spring
4. Grass deflector
Installing the Mower
1. Disengage the PTO and set the parking brake.
4
USE
6
3
2
4
1
7
Figure 2
5. Bolt, 3/8–3-1/2 inch
6. Lock nut, 3/8 inch
7. Raised back
1783
Advertisement
Table of Contents
