Table of Contents
Advertisement
Figure 5
Installing the Grass Deflector
The grass deflector is used when in side discharge mode
only.
Warning
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
grass deflector, a mulch plate, or an entire grass
catcher assembly.
1. Place spacer and spring onto grass deflector.
2. Place the grass deflector onto deck. Place the L end of
spring behind deck edge.
Note: Make sure the L end of spring is installed behind
deck edge before installing the bolt as shown in figure 6.
3. Install bolt and nut. Place J hook end of spring around
grass deflector (Fig. 6).
Important
The grass deflector must be able to lower
down into position. Lift the deflector up to test that it
lowers into the full down position.
8
6
1
1. Bolt
2. Spacer
3. Locknut
4. Spring
5. Spring installed
Using the Blowout Baffles
The blowout baffles are used when in side discharge mode
only.
Refer to Installing and Removing Blowout Baffles on
page 22.
Important
Do not use blowout baffles while in
recycling mode.
Using the Side Discharge
Blades
Side discharge blades are used when in side discharge
mode only.
Refer to Servicing the Cutting Blades on page 31.
Important
Do not use side discharge blades while in
recycling mode.
Activating the Battery
Bulk electrolyte with 1.265 specific gravity must be
purchased from a local battery supply outlet.
17
4
2
3
5
Figure 6
6. Grass Deflector
7. L end of spring, place
behind deck edge before
installing bolt
8. J hook end of spring
7
m–5037
Advertisement
Table of Contents
